|
|
|
#11
09-06-2019, 05:52 PM
|
||||
|
||||
|
Well I found a 220k ohm resistor on the H2. There is an H1 and H2. Obviously I cant read with a DVM. Could you elaborate on this low value resistor jumping?
Essentially increasing heater voltage it sounds. I still have a focus issue on the outside perimeter of the CRT I cannot achieve with dialing focus around. also blue and red smearing from weak R and B emission although it retains good brightness and contrast even with the smearing with my chassis derived rejuvenation. lol I know it's most likely a weak crt, just surprised it can retain a really bright raster with quite a bit of contrast, not like the usual Trinitron weak crt. But it does exhibit the smearing as contrast level goes up. And quite a bit out of focus around the perimeter.
__________________
Honey, turn on the tv.. I'm cold! Last edited by freakaftr8; 09-06-2019 at 07:14 PM. 
|
|
|
Threaded Mode