#31
|
||||
|
||||
The transformer will be wound with heavy wire & not much so you
will get very low ohms. Unfortunately the ZOOM doesnt blow things up enuf so I can see it. The hoz lin & pincushion usually will be in series with the yoke. Follow the hoz windings of the yoke from the collector of the hoz out transistor through. Watch for a yoke coupling cap in series with it. Also look for any diodes off the C of the hoz output. If any lift one end & do diode test with your meter. Yes I did do some monitors inc NEC. I am NO expert in them. In fact I hated monitors. I was doing piece work for a cat & told him " no more monitors , projos, or VCR / TV combos". All a PIA. Keep in mind monitors were fixed BOARD LEVEL ONLY as far as a MFG goes. Even getting a manual set you back $50 - $75. Add to that you could not buy parts ONLY boards. If you get this going you will have something to be very proud of......... 73 Zeno LFOD ! |
|
|