|
|
|
#2
01-28-2019, 09:36 AM
|
||||
|
||||
|
Zeniths typically had an electronic preset switch so yes you have to switch to automatic to use the presets... not familiar with that resistor, but at the least make sure it is not open.
It could be an inductor that uses a resistor for a form... that type places a sub 5 ohm inductor in parallel with a more than 10k resistor.... the resistor is so high a value comparatively that the circuit don't notice it exists. This was done because resistors were the cheapest forms available.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
|
Threaded Mode