|
#1
|
||||
|
||||
I don't know what the proper ohms should be on the Transformer on the speaker but I measured the primary input .730k ohms and the secondary to the speaker,2.0 ohms and the speaker coil itself, 4.5 ohms. I originally plugged it in and got the typical loud buzz and hum out of the speaker so if anything the speaker and coil should be good. The field coil that's on the speaker itself measures 1.758k
Last edited by timmy; 06-12-2018 at 12:11 PM. |
#2
|
|||
|
|||
Quote:
Those are all DC resistances on the output transformer, speaker and field coil and they look alright. Also the negative on the input electrolytic should go to the bias line instead the chassis. Also check the bias resistors, 400 and 75 ohm. |
#3
|
||||
|
||||
Quote:
primary does show its 450ohms I'm getting .730k. There is a 70 ohm resistor and it's ok but I don't see a 400 ohm resistor. the 190k I replaced with an array at 186k and the 490k I replaced with 470k . |
#4
|
||||
|
||||
Quote:
How long of an antenna wire are you using? jr |
#5
|
||||
|
||||
Well the schematic shows 190,000 so that should be 190k . Wire for the ant is like 3feet long.
Last edited by timmy; 06-12-2018 at 04:19 PM. |
Audiokarma |
|
|