|
|
|
|
|
#1
11-29-2023, 08:51 PM
|
|||
|
|||
|
Found my problem...I think. The vertical sweep output transformer has an open coil on the vertical deflection amp side. The set was only drawing 2 amps when it started to smoke so I better make sure I didn't just cook it by leaving it powered up for 10 seconds with an upstream issue or if it was gone from jump. Black tar was oozing out of it but it didn't look too bad. I have another one from a parts chassis but I don't want to cook that one too.
|
 |
|
|
Hybrid Mode
