Last post about my convergence

[TinCanAlley]

Okay, I should have the 10x probe for the scope tomorrow. Here's a questions about testing the convergence board. I see in the Sams that each of the test points corresponds to a lead in the convergence socket. It would be much easier to test the leads if the socket were disconnected. That way I could touch the probe directly to each pin in the socket. That's where my question comes in. Is it okay to run the set with the convergence board disconnected. I know the convergence will be way off and there will be no power to the convergence magnets. Other than that, would I cause any damage to anything?

Thanks!