#1
|
||||
|
||||
Tektronix 516
I have an issue with the Intensity control not having much effect on brightness, then all traces fade out after 10 minutes.
The schematic shows a circuit that controls bias on the CRT via R828, a 1 Meg. Could it be as easy as one bad resistor? IMG_1210.jpg
__________________
"When resistors increase in value, they're worthless" -Dave G |
#2
|
||||
|
||||
The image is really hard to read. Are you referring to the resistor in series with the intensity control?
Also, have you checked the three rectifier tubes? |
#3
|
||||
|
||||
Better images here:
https://w140.com/tekwiki/wiki/516 I would suspect the 3 caps near the intensity pot. jr |
#4
|
||||
|
||||
Thanks!. I will try the 5642's, I have a spare as well.
__________________
"When resistors increase in value, they're worthless" -Dave G |
|
|