Philco Safari Vertical Foldover issue

[goat1981]

Cool. Thanks for the reply. I'll check some voltages this weekend.

Are there any specific resistors I should check the values on? Specifically those that may affect the vertical height or linearity?

Thanks again for your help.

Originally Posted by Electronic M

I'd check voltages at the transistor pins with the set at reduced ans normal voltages and compare to what the schematic specifies.

Word to the wise whenever at all possible read the value off the original part you are replacing in the set, and NOT the schematic....I've blindly followed sam's and got bit by their numerous typos a few times, and now take all sam's data with a grain of salt.