#1
|
||||
|
||||
Are These Circuit Traces Bad
I purchased an NOS horizontal output board for my Avanti and upon installing it, nothing. There's sound, but no image. Not even the sound of the degauss. So I swapped back the old module and it worked again. I check everything on the top side of the module to make sure they were in their sockets, etc. Everything looked fine. It's when I turned the board over. I noticed that a few of the silver traces had black sections that look like the old laserdiscs had when they got laser rot.
Anyway, I'm attaching a pic and would appreciate any input. I bypassed the main canister today and it didn't help with the jail bars. I don't feel I wasted my time as I had already replaced all electrolytic caps earlier. Besides, the 500uf sections were 35% and 40% on the plus side and the 400uf sections were about 25% and 30% on the plus side. Not sure this makes too much of a difference, but the ones I put in are only 10% when tested. Thanks
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650 |
|
|