#1
|
||||
|
||||
Last post about my convergence
I know there is not such thing as perfect convergence on CRTs, especially older sets, but I need to get closer than I am. I'm used to seeing a little red or blue on edges of images, but they've always been less than an 1/8". What I'm dealing will on the right and left edges are separations of up to a 1/2" and covers 2" on the left side and 6" of the right.
I know it should get better than this. No one would buy a set if the convergence were this bad. Since I've done all the electrolytic caps, could it be a resistor or capacitor on the convergence board? I'm attaching a pic. Don't pay attention to the bottom lines. Those are lined up now. I had then lined up, but made them that way when tried to get the edges better. The sides are still as messed up, but not the bottom center horizontal lines.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650 |
|
|