#1
|
|||
|
|||
HELP lectrotech v-7 vectorscope
last week i got a vectorscope off epay for 10.00 ,it looks like it was never used much i even have the orginal box with it ,i tested it out and it worked only on color input ,so i went through it and found a dead shorted .05 cap now everthing works but everyone over the years must have tryed to adjust every pot and cap in it, im hoping someone here has one with the manual and schematic so i can get it all adjusted right and recalibrate it .thanks
|
#2
|
|||
|
|||
there must be a manual for this somewhere i see alot of these around.
|
#3
|
||||
|
||||
#4
|
|||
|
|||
thanks for the help, are they only showing two pages of it, or is there more ,im having problems downloading from that site , after they attack you with junk i still dont know where it was downloaded at. lol
|
#5
|
||||
|
||||
Looks like only the schematic and parts list available.
|
Audiokarma |
#6
|
|||
|
|||
ok thanks , i was wondering if i just dint know how to get it all ,when i got the v-7 it had a single paper showing all its features and there's a part in the manual that shows how its self calibrated, thats what im looking for it seem to all work now but its all out of wack from everone adjusting it,and there is a set of red and black leads that i dont know what there for , ill study the schematic maybe i can figure out what leads and how it works .thanks again
Last edited by snelson903; 07-08-2013 at 04:28 PM. |
|
|