|
#1
|
||||
|
||||
It's only 9 degrees outside, and while the Mercury will fit in the garage, it's not deep enough to really work on it with the door shut. And even with that electric heater going for 2 days, it's only any warmer within a 2 foot radius of where I left the heater.
I've found it has to be at least over 20 to work on anything outside. I can wear lots of coats, but I've found that under 20 degrees I either have to choose between wearing thick gloves or having my fingers go numb, neither of which lets me do much of anything. But you guys have given me some good stuff to think about, as soon as it warms up a little I'll check those coils. The check engine light goes off like crazy, but I thought those code readers were hundreds of dollars (I think they were the last time I looked them years ago), so I just didn't bother with it. Any recommendations on a good one, not too expensive? I think I'm just going to stop trying to ineffectively heat the garage with that electric radiator, and bring whatever electronic stuff I want to work on inside. I can use my desk in the basement, or even the kitchen table - I'm here by myself for the next 2 weeks.
__________________
The quality goes in, before the cat goes on!! |
#2
|
|||
|
|||
Quote:
In this kind of weather, you might have bite the bullet and see your friendly Ford dealer. When I was younger, I used to work on my own cars as much as possible, but not in this kind of weather. I'm about 90 miles north east of Madison and it's damn cold here. |
#3
|
||||
|
||||
The little ones have been getting steadily cheaper. If you want a real scanner that can do everything, $2k minimum.
Here's a cheapie basic one This one is still decently priced, but will also let you look at live sensor data. I have a slightly-higher model one of these (model 6001) that I use daily at my shop for quick checks. I would definitely recommend getting one with data stream capability. Not all cars have it in the data, I don't think yours does, but some have a misfire counter for each cylinder in the data. Still, when other problems arise, data is very helpful. Without codes and data, it's kind of like working with your eyes closed. And I don't know if you have emissions tests up there, but any of these little scanners will tell you if it's passing (I/M readiness). Also, it's always good to have one of these around to check on family's and friends' cars. They have some other ones that are just a nub you plug into the car, and download an app on your phone to read it. Haven't yet tried any of those. Also I was just at Harbor Freight the other day and I peeked at the scanners there, I think there was a half-ass decent one for $45 or so. Last edited by MadMan; 12-25-2017 at 02:33 PM. |
#4
|
||||
|
||||
Quote:
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
#5
|
|||
|
|||
Quote:
The state of Illinois had the nerve to blame us for their air pollution, so it all the counties nearest the lake have to have it done. I take my vehicles to the auto repair and tire center in Port Washington and they issue a printout and notify the DOT. All 96 and newer that use the OBC-2 module. |
Audiokarma |
#6
|
||||
|
||||
Quote:
If you needs coils you can get an entire set from Amazon for $30 & up. The codes for specific cylinder misfire are P030* with the last digit being the cylinder number. P0303 for example would be cylinder 3 misfire, (remember on a Ford #3 is the third cylinder back on the passenger side). If you can narrow it down to a specific cylinder or cylinders it will save a bunch of time. |
|
|