|
#1
|
|||
|
|||
Quote:
When this set was new, I was 30 younger and a lot stronger. Now I can still carry the set, but not by the handle. I've been retired for 12 years at the age of 62. |
#2
|
||||
|
||||
My apologies, I'm 53 and grew up with old military boat anchor shortwave radios and tube console stereos. I never trusted any electronics that weighed less than 40 lbs except for those new fangled light weight zenith solid state transoceanic radios.
|
#3
|
||||
|
||||
For Zeniths with 9-86 & older flat & hybrid chassii (9-27).
clean, tighten & reset module. Boards with socketed IC's ( up to F line IIRC) should have IC's soldered in. The sockets are more trouble than the IC's. Clean normal-align switch, APC & ACC pots. Adjust APC in align for fewest color bars. Dont remember ACC procedure. The IC's are super common & used in other brands. A few stupid things are color turned down, FT off, dirty Chromatic or Color Sentry switch ( when used ). Barely any off board parts will cause no color. Actual fails will be an IC 95% of time. BTW ANY Zenith with modules & plug in semi's always suspect the sockets especially if intermitant. Starting around F-line (1975) they were eliminated & all Zenith rebuilts had sockets removed. 73 Zeno LFOD ! |
|
|