#91
|
||||
|
||||
The FD-20 doesn't look too bad - I had a lot worse on the 1 I gave away, severe pincushion and trapezoid deformation. The FD-210 looks very good.
|
#92
|
||||
|
||||
Quote:
The FD-230 is a good set, solidly built and with a 2.7 inch screen.
__________________
Just look at those channels whiz on by. - Fred Sanford |
#93
|
||||
|
||||
does anyone know if the plastic front cover can be removed for dust cleaning on the sony fd-10. i know the fd-20 has 2 screws to remove the front for cleaning. i dont want to pry on the fd-10 and break the front.
|
#94
|
||||
|
||||
Quote:
jr |
#95
|
||||
|
||||
well its not that bad with dust or dead bugs so ill leave it, thanks.
|
Audiokarma |
#96
|
|||
|
|||
...
Last edited by andy; 12-05-2021 at 08:04 PM. |
#97
|
||||
|
||||
i noticed that on the fd-10 when the back is taken off extreme care must be applied in putting the back, back on because the micro switch for uhf-vhf broke when i put the back on as i didnt line up the position of the swich relative to where the slider is on the cover. the micro switch has a very thin plastic tab and will break if you look at it the wrong way,lol as mine broke. so i put a little crazy glue to keep the switch in the vhf position.
|
#98
|
||||
|
||||
Quote:
__________________
Just look at those channels whiz on by. - Fred Sanford |
#99
|
||||
|
||||
yes i found that the plastic is infact soft. well the cheapest way to make them, they did.
|
#100
|
||||
|
||||
But how in the world they made the deflection when the gun was underneath?
|
Audiokarma |
#101
|
||||
|
||||
Quote:
jr |
#102
|
||||
|
||||
Quote:
If you had asked a few months back I'd have given you a working Sony paddle CRT set for the cost of shipping.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
#103
|
||||
|
||||
Quote:
The first generation design employed a flat phosphor screen at 90 degrees to the electron gun. A combination of magnetic and electrostatic deflection was used to achieve proper landing of the beam. http://www.videokarma.org/attachment...5&d=1256418738 jr |
#104
|
||||
|
||||
Were any of these micro sets made with electrostatic crts ?
|
#105
|
||||
|
||||
Here is a picture from post #3 of this thread, showing the electrostatic crt that was used in a Sinclair portable:
http://www.videokarma.org/attachment...7&d=1256418738 post #3 : http://www.videokarma.org/showpost.p...14&postcount=3 jr |
Audiokarma |
Thread Tools | |
Display Modes | |
|
|