Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 02-07-2019, 09:34 PM
keith6996 keith6996 is offline
VideoKarma Member
 
Join Date: Jan 2019
Posts: 5
Philco 48-2500 projection tv

Hello Gentlemen

Last spring I found a Philco 48-2500 at a flea market for the can't refuse price of $7 dollars. The cabinet was fair to good, but what impressed me was the set was complete. Most of the tubes were vintage philco (4 tested bad). I changed out all the caps and a handful of out of tolerance resisters.
I got some great tips from this website, especially from Tom Albecht about going to a solid state voltage Tripler which I installed and pulled the dc restoration tube. The focus became consistent and improved the picture.

The problem I have now is a light vertical bar in the middle of the picture. I can move this bar slightly to the left or right by adjusting the horizontal hold control. Could this be a horizontal phase problem ? I carefully went through the damper and horizontal circuits and changed any out of tolerance resisters, but I suspect the problem could be elsewhere.
Please check out the picture.
I would appreciate any suggestions !

Thanks

Keith
Attached Images
File Type: jpg IMG_2143.jpg (48.8 KB, 60 views)
Reply With Quote
  #2  
Old 02-07-2019, 10:32 PM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 10,498
Looks like a drive bar...Caused by setting the horiz drive too high.
__________________
Tom C.

What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4

Reading between the scan lines since the mid 2000's.
Reply With Quote
  #3  
Old 02-08-2019, 07:27 PM
keith6996 keith6996 is offline
VideoKarma Member
 
Join Date: Jan 2019
Posts: 5
Unfortunately this particular set doesn't have a adjustment for the horizontal drive. I believe it's using fixed resisters. Reading a thread from Tom Albrecht, he increased his horizontal drive by adjusting the value upward of 2 resisters. I can adjust these the other way to see if this makes a difference. I'll probably pull the chassis out this
weekend to take another look. I'll keep you posted.

Keith W.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:47 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
ęCopyright 2012 VideoKarma.org, All rights reserved.