#5
|
||||
|
||||
Installing the manual RF-IF output level DPDT toggle switch requires moving wires from the RF-IF switch to the DPDT switch. Here is how
1. Locate the back of the RF-IF switch. It looks like this 2. You need to wire the DPDT toggle switch like this 3. Remove these wires and label them. ONE AT A TIME. 4. Put some heavy tape (I used red duct tape) onto the front panel between the AUDIO and the RF-IF LEVEL switches 5. Put some tape on the back to catch the drill shavings 6. GENTLY drill a hole for the DPDT switch Last edited by Zenith6S321; 09-23-2016 at 07:30 AM. |
Audiokarma |
|
|