Videokarma.org TV - Video - Vintage Television & Radio Forums - Anyone have any Zenith Convergence Coils?

Quote:

Originally Posted by zeno (Post 3079363)

For diddle sticks.
http://gcelectronics.com/order/SubCa...%20380-387.pdf
For hex tools there are 2 common sizes. The Zenith uses the
most common on & there is a smaller one sometimes used.
Also a square one for RCA. Screwdriver ones are mostly used in JP sets
& small radio.
Another tool that are almost a must have is a LONG 1/4" (#8)
nutdriver. Xcelite used to make it. About 30" long with a
magnet, gets to screws holding tuners & deep in anywhere.
Be sure a used one isnt worn. Should be lots of NOS around.
They also made a yellow handled one (dont remember size)
and a phillips. The phillips is essential for some old JP sets.

73 Zeno:smoke:

Well then it looks like I make the right purchase the other day. Spent some time searching as many ways as I could figure in order to find them. I ended up finding the 9 piece set from the company in your attachment. They should be here early next week. Just in time to adjust the new coil I am installing.

I'd love a long nut driver. What I've been doing is putting together all of my bit holders together to make a long one. Only issue with it is that it flexes like crazy and I have to hold it about 2" higher on the back end so the head is at the level of the fastener. LOL!