Not sure about the adjustment... my guess would be width??? Your Sams should tell you.

Your 6V6 is audio output? If so, even a weak one should work in there just fine. Might not do as well in a nice stereo amp, but in a TV audio circuit, you probably won't notice any difference.

"Your 6V6 is audio output? If so, even a weak one should work in there just fine. "

Does this set have a "stacked" power supply circuit... In that case, a weak audio output could perhaps adversely effect the B+ voltage on the IF tubes. :scratch2:

jr

Close, it's the horizontal linearity.

Jr Tech and everyone who's interested go to
http://www.videokarma.org/showthread...ylvania&page=2

and scroll down to post #28. I attached the schematics for this chassis there.

John

I don't know what it is about the 6T8. Mine was bad and I replaced it. The new one tested good for a few hours, but then one section became weak. It still does its job though.

John