Quote:
|
Originally Posted by Marlin Mackley
. I will start by offering parts off of two sets I want to pitch. I have an RCA 8-T-241 chassis complete except HV cage cover, CRT, and cord, and might already have a home for the power transformer. I have the safety glass and crt bezel also. I donno how hard they are to remove but I am willing to try.
|
Hi Marlin, I need a back cover but what I need REAL BAD is a matching set of knobs. Especially the channel selector stuff. I would like the crt bezel as well. I take it this set is a table model like my 8-T-243. If so the whole front comes off as a panel. I would like the whole panel really and was hoping yours was the "double d" type. I like that look better than my fake rectangular bezel.
As far as chassis parts go it sounds like a lot of the good stuff has claims on it. I could use an extra flyback, yoke, and the large multisection resistor mounted on the rear under a metal cover.
A set of knobs and rear cover are the only important needs that I have....
Thanks in advance if you can help....
.