|
Maybe this will help
Hi,
Sounds as though the yoke has slipped from it orginal setting on the picture tube.
The yoke is the big plastic thing that slides over the "neck" end of the picture tube (the back of the tube).
Look and see if the rubber wedges are in place from the tube to the yoke. If the yoke has slid back or the wedges are gone you will see the print where they were on the back of the tube.
If this isn't the problem then I would try replaceing the color board or "chroma" bord. Sometimes just cleaning the connectors will do the job.
Hope this helps.
Chas.
|