|
Changing the resistor on the neck board had no effect, and Rat Shack didn't have any 10uf 200v capacitors, heading to Fry's tomorrow. What's funny is that the resistor read 150 (incorrect) yesterday, but 220 today (correct). I changed it anyway.
I tackled the chassis today. I found a .2 ohm resistor that reads anywhere from .4 to .7, it fluctuates wildly, and another 2.5M resistor that read .4. I will try swapping these out tomorrow once I buy replacements from Fry's, but I'm losing hope on this monitor. I really doubt those two are the problem, as they were some of the first I tested and they were bad. By the way, I test all of these after removing them from the board, 9/10 times I get funky readings if I don't remove them from the board first.
|