|
Bad news.... found some bad caps and swapped them, also did a lot of cleaning to the neck board, there was a load of brown crap all over the place (dried flux I believe). Now, when I try to power on the monitor, I get no degauss, no HV, and no heater voltage. The power light turns green and starts blinking. I'm positive I got all the wires hooked up right.
Help? I knocked a SMT resistor off the board by accident, the value was 0.01MF, 50V. Surface Mount pisses me off, that thing was smaller than a crumb. I was unable to get it back on, then I lost it, so I bridged the two connections with solder. Could that be it? This was on the neck board.
|