|
It may be...
I fooled around with it, and couldn't get it to do anything, even after it was on for a while. It seems to work ok now. I tried swapping tubes, I replaced any resistors which tested a bit off, and swapped out all the mica caps that had anything to do with the horiz, (as before this set had a strange intermittent horiz problem caused by a mica cap - I thought maybe others might be doing the same thing). I also changed the horiz hold control as it was a bit scratchy even after I cleaned it a few times, the shaft is about 1/4" too short on the replacement though.
Last edited by Adam; 09-13-2009 at 10:36 AM.
|