Ok, I got a VA-48, and the signal output is dead (not the RF one - that works). Now, i called up Sencore and asked if they had a schematic. They do but -get this - they wouldn't send me a copy of it "Because it won't fit on out copier, sir". I wish I was joking.
Anyway, the small circuit board under the chassis with the two thin heat sinks - there's two wasted resistors that burnt - R2 and R6. i need the values of these two resistors.
Apparently, TR 8 and TR.6 died, but I've got those vlues. and TR 3 los suspicious.
Anyway, if anyone's got a VA-48 schematic or can pop the lid off the bottom of theirs and tell me what R2 and R6 are, it'd help me out a lot.
thanks!
