|
Look for a resistor that has probably increased in value. Some people say as long as its no further than 20% out of value, leave it alone. If I have a schematic I tend to go with the tolerance listed. Naturally the higher the value the bigger the increase in resistance. I think thats why folks think that the higher values are more apt to large change of value. Anyway it is always easier to find a bad resistor than a bad cap in my mind. Less variables I guess. You do have to disconect one end on many of them to keep from getting the reading of a lower value resistor I believe in parallel. Series doesent matter. Someone correct me if I'm bass ackwards on this. This may help you some as it is highly probable if you didnt go through them when you replaced the caps.....
|