|
I just tested all of the basic voltages (nothing over 1kv) and found most of them to be in line. If you want to follow along, SAMS 438 is where you want to be. This is model cb137.
Okay, now there were a couple of voltages that were off: namely the plate voltages of the 12ax7 sync seperator, 6cm7 vert multiplier, and the 6dt6 audio detector. All plate voltages were off by about 30 percent.
The most alarming reading came from pin 4 of the HO tube, 6dq6 it was less than half of the prescribed reading. Curiously, this more or less connects to nothing else but 3 components that all test normal and then the 265 volt source which tests just fine. So about 70 extra volts are being lost here (should read 140 at pin 4, reads 60 instead). Hopefully these readings will be of some help.
|