I found three caps that looked like mica or bakalite. Two were
[email protected] and one at
[email protected] . They were original and stamped . Replaced all three . Now i have 3/4 of a screen , which is a improvement however not there yet . I can fill 3/4 of three screen with height control at its max .I checked all resisters in this set and they seem ok or within range of what they are suppose to be . Only found one way off which i replaced. There are a couple of mica caps which have not been replaced yet , however they dont appear to be in the directly in the vertical circuit . I sprayed the controls with de-oxit and also gave the tube sockets a quick spray . Even wiggling the tubes in the socket makes no difference, so i guess i can rule out bad connections . Guess i will continue my trouble shooting tonight . Got my isolation transformer in yesterday . Got a question . Can i pull the high voltage sweep chasiss and being the a/c plug does plug into it , can i take voltages on the bench with just that chassis or do i have to pull the other chassis and have the yoke connected . The schematic i have seems to be correct so far .