|
I did check all the tubes in this set on a tube tester, and replaced those that measured weak. But testing in circuit is a good idea now that I have everything running.
By the way, I need to rig up a ground lead for the CRT - I'm just using a clip lead to the mounting strap, which has a dag contact spring. Hypothetically, there is a ground path from the dag to the strap to the mounting bolts to an existing ground wire, to a bowed contact spring in the front of the cabinet (the one remaining after I broke one -see previous post) to the chassis. However, the chassis contact spring is a bit rusty, and the contact is poor to non-existent. Need some sort of clips that could clip onto the mounting strap on one end and the chassis on the other.
**Any hints about the width and H linearity would be greatly appreciated. I do have it on a variac and line meter, tried raising the voltage a bit, but that is not the fix.
|