[Eric H]

This is my first attempt to re-dag a tube using SlipPlate and it looks excellent if I do say so myself.

Years ago I was actually able to buy a spray can of Dag and this stuff seem to pretty much look and apply exactly the same.

I probably coulda made the anode circle a little bit smaller but what the heck.

For the anode circle I laid down several strips of Masking tape on a cutting board, slightly overlapping each strip.
I drew a circle using a drinking cup, then I marked the center of the circle by eyeballing it, after that I peeled up the tape and cut out the circle with scissors, then I applied it to the CRT lining up the center marking with the anode connector.