|
YES i am certain there is no high voltage . The second anode test dead with high voltage probe and usually you can even hear high voltage and there is nothing . THe crt filiment does light up . The whole set has been recapped . All electrolytics, wax and bumble bee caps . The only caps not replaced are the mica caps . The horz output, damper and rectifier tube have been replaced with new ones . The crt has a crack on the side of the bakalite plug but no damage to the tube or electrical connections . Its still on there pretty tight and secure . I tested the crt with the beltron . Its ok , comes up a bit slow but its ok . In one of my other posts i was just curious if there was a sub being a have a bunch of new old stock tubes in my attic that i could use if needed but unfortunatly they dont sub . No big issue the one i have i believe is good but would have loved to use one of these new ones i have being the tubes take up half of my attic and i am cramped for room . Anyhow i began testing some of the resisters and thats where i am at . The horz oss tube and frequency tube are a 6sn7 and test good . I have not tried swapping them out yet with new ones becuase i dont think thats the issue but i might go ahead anyway and try it . Well hoppefully tonight i can dig a little more into this set .
|