|
Checking ceramic resistor
I checked the ceramic resistor in circuit and no opens. Should I disconnect it to check or is in circuit good enough? I was told that between 2 and 3 it should be 2450 ohms and I only have 180 ohms there. How do I know what it should be? One 24 has a plate voltage of 273, 1st tube, and the next one only has a plate of 103 volts. Can't see why though. I replaced the caps inn the power supply with electrolytics, 10's, but the cap across the choke I left as is, would it be the problem?
|