[roundscreen]

Eckhard. I have some 6Cg7 readings withAC@110. B+292v{filters check ok} horz current 205-206 ma. horz drive -28 {changed some caps}.
pin 2. - 18v
pin 3. I get .140 dc and 20v when I switch the meter to ac {may be my meter is loading it down}
pin 6. 200v { meter loads this line down too and horz lock goes out}
pin 7. -65v
The picture dosen't look that great but you can see the bars look almost the same width. The sides of the screen are in a little with the width set to the middle. When I turn the width to high the bars look normal with an increase of 1ma on the horz current This set has a 21fjp22 in it. When my buddie had it The crt blew out when the flyback started to cook. Took out the 6bk4 and other parts too. I used this cabinet as a jig to repair my other chassis. Did not want to work around the 21axp crts.{Accident prone}. Question. Have you done any adjustments to the horz lin coil? You may want to try and put your finger on the horz lin coil to see if it gets warm or hot run the set for 15min then check it. You can take the screen off the bottom of the set and be able to put your finger on it. Also if you adjust the horz drive up. Do you get a fold over on the right side of the screen?
ED