Quote:
|
Originally Posted by mbates14
I redid the dynamics, and i got the bottom and center to perfectly converge, but the top and the extreme right wont converge. If i try to converge those, it throws the rest off.
|
Perfect convergence is not always easy to achieve. In most cases, you will not achieve "perfect" convergence. Like you said, you adjust for one side, and it throws off another side. It's a real pain in the butt!
Sometimes you must go thru all of the steps 2 or 3 times to get more improvement. I usually end up doing it several times before I reach a point that I feel is acceptable.
At least, you've improved it greatly since yesterday.
Also, take note of the temperature of your alignment tools after taking them out of the coil. If you happen to notice that the tip is unusually warm after removing it from the coil, that particular coil could have a short.