Quote:
Originally Posted by rollei35guy
Another possibility you should consider is that there may have been others before you. Changes may have been made and not necessarily the right ones.
You can check against the schematic but that raises the possibility that there may have been production changes. In which case the schematic might not match.
|
Well, Whomever had this set before me added in a resistor that totally changed the filament line which I put back to the diagram. They also replaced one resistor with a high watt. "brown Bar" resis. and placed it on top of the chassis but did not make sure that the wires going to it did not rub off the coating and short to the chassis. They then also cut out caps completely and put them in a pile in the cabinet. Fun, huh?