|
That chassis is looking pretty good! Your experience with the white line will be helpful to the rest of us also.
On my Sylvania I'm supposed to adjust the horizontal linearity until one shows up in the center and then back off. I used to get this before I finished fixing some other problems, but now I can't get the white line back. They say to leave the pot. at max in that event. I feel nervous doing that. I still backed it off some.
I have several HV probes. Though they all seem to be calibrated properly, two of them draw a lot more current than the other. Those two read lower when I use them because they cause a big drop across the resistor that's in series with the HV CRT connector. They do seem to read correctly on sets that have lower impedance HV supplies. Sounds like you're having the same experience.
John
|