|
Before I do anything else, I am going to make a degausser coil and give it a good degaussing. then I will check.
I am going to buy some 22 gauge wire, and wrap around a form about 18" until its about 1/2 thick. Thats about what I recall them looking like.
After that I will go ahead an pull the chassis and look over for caps and out of spec resistance. There was no bypass cap on the vert osc tube so I will check it with a new tube and if need be adj the pot.
There are a few board mounted electros so I will check them as well as the cans, although I suspect the cans are ok.
I vac out all the dust so I could see things better, no obvious problems.
I am assuming the tuner is a waffer switch type. it will need some cleaning.
its got a few 6GH8's which is fine since I picked up a bunch of NOS ones at a local hamfest (a bunch of rat shack life time tubes).
|