|
how did you find that cap swap? did you just go over the schematic again?
I often get antz when doing recaps that involve multiple caps to a single tie point (like a floating ground on a term strip) since I desolder and undo them all at once. I try to insert one leg of the replacement cap in place as a place holder, but I have to admit, its kinda unnerving esp when going at a shot gun recap with out the schematic (which is how I did the TS-14)
Glad you got it up and going. I wonder if the TYPE of resistor is critical on that damper setup as in WW or carbon?
|