Thanks!
Well I started to diagnose further today, and I noticed two things. After poking around the "E" board, I found a cold solder connection between one of the cracks some dude tried to repair. This goes to the center pin of the LOT transformer. And then on the "P" board, one of the connector pins were totally disconnected from the board. This connectoer wiring carries around to the "E" board LOT CONV side. I believe this means Convergence?
Anyway resoldered bad connections and still no HV. Im still assuming the HOT transistor is shot from all the crappy solder issues.
Is there any way to do a goot test with the transistor still soldered to the board, cause I get different readings between the CONV and the HOT transistors. They use the same Hitachi 2SD725 Silicon NPN style.
http://i845.photobucket.com/albums/a...6/DSC01688.jpg
http://i845.photobucket.com/albums/a...6/DSC01691.jpg