|
thanks you for the hints, I was not sure about the cage being off but wanted to so I could see if I could find the arcing so its good to know I can do that briefly, I did do some soldering down there and cleaned it up today finding a loose resistor that I might replace tomorrow it is a bit out of range but still ok I did notice a small crack in it so that could be the cause of all of this. It is also not a great place to try and work on since there are two resistors shoved under the base of the rect. and over the doorknob. I only asked about the doorknob because one of the leads turns but it is still very tight.
|