|
All right, so you just locate a station near the top, ascertain the frequency, and
then adjust the oscillator trimmer to bring it to the correct spot. A simple comment,
alignment can be done on the bench with a signal generator, just jamming the needle
at either end of the range, and using the two frequencies specified (530 and 1620),
or in fact just the higher one since the coil is non-adjustable.
I don't think you need to worry about a bit of surface rust. I think your electrical
restoration is nearly complete. Congratulations, I look forward to the update in
your site. And I believe I already got all the credit due to me, which is not that
much, after all you did all the manipulations! This thread possibly contains more
posts over its lifetime than all the rest of videokarma, and I believe this means
something...
|