|
I just use the reg dust off, hold it upside down and you will get some cools stuff.
yes sockets are often a problem, you could try just wiggling that tube around.
I had a couple bad sockes on my princess. Also the pcb ground stakes can cause issues, I had a intermittant damper filament that was traced back to a poor solder joint on a ground stake.
FYI I was able to replace all but one or two of the caps without pulling the pcb, so if your sockets are ok you may want to try that approach and not make more work for yourself. Good luck with it. I love my predicta, watch hitch on it every night.
|