|
Couple of points:
Shellac: I have given up on using shellac as a sealer as it goes bad in the can, etc. Now use Deft Sanding Sealer.
Metal Work: using plain or perforated metal available in sheets from home centers, it's not too hard to bend up a box. I've made a number of parts by clamping metal to the work surface with a board across at the bend line, then bending up with another piece of wood sort of hinge style, finishing with a hammer and a block of wood. A brake would make it easier, but good results can be had by hand.
__________________
Reece
Perfection is hard to reach with a screwdriver.
|