[tvcollector]

I just did a test on the CRT using the universal Adapter on my Sencore CR70 following the instructions on where to put each labeled connector on the numbered pins, I set the voltage as followed, and when i get to the cut off setting, needle doesn't move when i power on the Sencore to set the cut off in between the range, also adjusting the the cut off does not make the needle budge, Also i go into emission test, needle does not move, when i check for G and HK shorts, needle goes to the upper good side, also the Sencore does not power up the tube (Makes it light up).. I'm guessing maybe the pins are not making contact, some of the pins also wobble real loosely.. I wonder if this is going to be a problem..

The crt is a 12Lp4..This looks to be a color set?