|
there was some audio signal in the video, I tweeked the 4.5mhz trap to minimize it. One of the converg board coils is stripped so its a bit iffy on holding the blue horz right. I may try the thin rubber band in the coil trick.
I get about 220ma at 117vac. it will go to 250 at the normal line voltage of 125vac. I have been toying with the idea of adding a term strip that would let you select differnt HOT screen voltages. On one of my zeniths (20YC138 IIRC) there is a jumper that lets you select different screen voltages so you can use different HOT's, seems like a good idea that may work for high line voltage. HV seems good, very little fluctuation.
I did a purity setup and a convergence (as well as I could considering the loose coil). Soimeday I may attempt a cat removal, its not that bad, so it not high on the agenda.
|