|
T4's secondary reads spot on at 7.5 ohm. T4's primary which is supposed to read 700 ohm is reading twice that 1.4 k ohm.
T2's secondary which is supposed to read 1.3 k ohm is reading 1.4 k ohm. I'm assuming that is well within accepted tolerance levels. T2's primary is supposed to read 160 ohm. It is reading wide open.
R3 is good to go at 5 k ohm and adjusts as I turn the control.
The tester that was used to test the 6C4 had a leakage detector and it tested good there to.
So it looks like my problem is T4 and T2? Are those parts that one can find?
|