Quote:
Originally Posted by stusnyder
I can try to test some of the voltage points....if I can figure out where by the schematic...
|
If you look at the schematic near where the power transformer is drawn, you will see the sections of the divider resistor. Measure the junction nodes indicated with respect to chassis and provide us the readings against what it should be. For example, downstream from the 5U4 at the first node (section A of C148 elctrolytic positive it should read +215v to ground. You could measure from the focus control as that is a convenient access point.
The next point should read +135 volts to chassis.It may be accessed at C148B positive connection.
The voltage at the C147C positive should read -60 volts to chassis and the can of C147 should read -120volts to chassis.