|
thats all for tonite, I checked the .001 2kv elmenco on the primary of the vert out, value right on, no fuzzyness, no leakage at 450v (which is high as I can go). I would have replaced it anyway, but I only have some dipped that go to 1.6kv, so I will have to order some of those (I dont trust them).
there was a single black plastic .01 400v sprauge in the horz osc section, it tested perfect, no leakage at 450v so I left it alone.
I am trying to not make too many changes just in case I goof something up, it was working after all but for the horz AFC.
I did check the vert osc bypass cap a 50uf 150v, tested perfect again I left it. I randomly check a few of the purple dipped caps a .47 and a .1 both 200v, they checked fine, no fuzz no leak so maybe I will get lucky on this set and dipped caps.
that bumblebee across the line was fuzzy and very leaky, I am suprised it had not blown up yet.
I did have one open cap, a 100uf nichicon 25v that I think is part of a degaussing circuit. I see a diode and a relay all tied into that blown large VDR that is around the degaussing circuit.
|