Progress Update - One section has been totally recapped and most of the resistors have been replaced. Some checked fine, others were way off.
The area I did was in the horizontal drive/osc/sync section. The horizontal sync is now stable and the picture locks in perfectly.
I have to admit that some of those old components were a little tricky to get out, some of the caps were buried underneath others, thankfully I took upclose photos and drew some rough diagrams so to resolder all the new parts in the right place.
I also checked those mica caps just to be 'sure to be sure'...They all checked fine.
Have now started on the vertical section....And that's where I'm at
Photos are of the repaired area and the dead bits including a slighty better picture showing a test pattern this time.
Cheers
Glen