Quote:
Originally Posted by leadlike
What's the filament draw on your set going to be?
|
No idea, but this filament PTX came from an organ which always have a bazillion 12AU7's in them. I don't think it will be a problem as far as that goes, I just hope I can come up with all the B+ supplies it's gonna need. I think right now I'm looking at a 250-ish rail, 380-ish rail, some yet unknown B- supply (maybe around ~100), and possibly a small positive bias supply. Interestingly, one of the filament windings on the B+ PTX is 6.6v center tapped... I guess I could always run 5U4's at a volt more than normal, but perhaps 3DG4's would be more appropriate?
Then again, it's entirely possible that the voltages will get a little lower once the thing is loaded down really good.