Quote:
Originally Posted by DaveWM
there is a 1800 ohm 5% right after the delay line (back thru a coil then the plate circuit B+ of the 2nd video amp. there is also a 2200ohm resistor across a peaking coil after the coupling cap from the delay line that goes to the grid of the video out, will check that one as well (prob did not check before since it was in P with the coil so will have to take out of circuit to check, same with the 1800 ohm (will have to take out of circuit, will prob just replace both).
Question, do those need to be carbon comp resistors? or will metal film be ok?
(the post delay line and the one across the peaking coil).
|
Metal film will do just fine